46 Results
View results:
Sort by:
Power Plants and Conveyor Structures
Which programs can I use to design power plants and conveyor structures?
AutoCAD Import into RFEM 6 with Cross Section and Material
How can I import my AutoCAD model into RFEM 6 and have the cross section and material information transfer over?
Welds in RFEM 6
In the case of stairs with a complicated geometry, it is often difficult to design welds by using the analytical methods. How can I do this with RFEM?
Load on Non Coplanar Structures
How do I apply load on members that are non coplanar in RFEM 6?
Wind Load on Open Structures
How do I apply wind load on members of open structures in RFEM 5?
Question
I want to create a mapped mesh for a circular hole plate. Is it possible to generate such a mesh in RFEM?
Question
How can I optimize the calculation time in CRANEWAY?
Question
How do I create a frame joint with taper in JOINTS Steel - Rigid?
Question
How can I create a drilled beam in RFEM?
Question
When importing a model directly from AutoCAD, the shape of the "spline" is sometimes incorrect.
Question
How can I additionally model welds for the connection of two surfaces with a contact solid?
Question
In connection with a calculation according to the large deformation analysis, I get significantly smaller deformations than for a calculation according to the linear static or second-order analysis. How is this possible?
Question
Is it possible to also have RFEM output the area of each finite element along with its location?
Question
I get a message saying that the General Method is only allowed for I-sections, even though I do want to design an I-section. Why?
Question
I have calculated a box girder. Which surface results or surface stresses can I use to evaluate the buckling behavior of the web plates?
Question
When entering data in the RF‑/STEEL EC3 add-on module, I get the error message "Incorrect location of the intermediate lateral restraint". Why?
Question
When creating a material, there are no nonlinear material models available for surfaces or solids. Why?
Question
When trying to import a model from AutoCAD into RFEM, I am getting the error message: "3DSOLID or REGION entity detected. Those entities are written in binary format, so import is not possible." What does this mean?
Desing in Industrial and Plant Engineering
Are Dlubal Software programs applicable for the analysis of process manufacturing plants?
Question
Are direct import and export possible with Autocad?
Question
Which interfaces are available for export?
Question
How can I deduce the axial stress and hoop stress of a circular container?
Question
How can I connect surfaces to other surfaces or members in a hinged/semi-rigid way?
Design of Piping Systems
Is it possible to analyze and design piping systems with Dlubal Software?
- 004165
- RFEM 5
- RSTAB 8
-
- Power Plants
- Steel Structures
- Process Manufacturing Plants
- Bridges
- Towers and Masts
- Temporary Structures
- Scaffolding and Rack Structures
- Offshore Structures
- Silos and Storage Tanks
- Buildings
- Piping Systems
- Cranes and Craneways
- Renewable Energy Structures
- Conveyor Structures
- Drilling Structures
- Stairway Structures
- Wind Simulation & Wind Load Generation